Bus Tube is heat shrinkable tube designed to insulate busbar systems up to 36KV & to protect against accidental flashover. The tubes are manufactured from high quality non tracking crosslinked polyolefin material. Meets ANSI C37.20.2 standards for MV switchgear application up to 36 KV.

Bus boot is flexible electrical insulating boot / shroud for busbar and switchgear connections upto 36KV. These pliable boots can be installed, removed or replaced in few minutes. Made from specially formulated Polyvinyl Chloride (PVC) material to provide excellent electrical insulation and to withstand higher operating temperature continuously.

Busboot provides reduction in air clearance, which helps designing compact panels; thereby reduces the material costs by. saving in busbar lenghs, sheet metal components, etc.

It is also call as busbar connection shroud / busbar joint cover, protection shroud(boot) etc.

Busboot - Polyolefin is flexible electrical insulating boot / shroud for busbar and switchgear connections upto 36KV. These pliable boots can be installed, removed or replaced in few minutes. Made from high quality Cross-linked Polyolefin material to provide excellent electrical insulation and to withstand higher operating temperature continuously

It provides reduction in air clearance, which helps designing compact panels; thereby reduces the material costs by saving in busbar lengths, sheet metal components, etc.

Finotube-wire marking / identification is cross-liked polyolefin heat shrikable tubes used for identification and insulation of wire, cable, Terminals and other components

The product is intended for interior and exterior markers. it is recommended for both, dot matrix and transfer thermal printers. the tubes can be printed on both sides for maximum data content and readability.

After shrinking, the imprint is permanent and solvent resistant.

Bus Tape is heat shrink tape specifically designed for insulating and protecting medium voltage Bus Bar Connections. It is very conformable, tough, waterproof tape with special adhesive coating which bonds well to most surfaces over a wide range of temperature.

The shrinking action achieves exceptional conformation to contours, squeezing the adhesive into all surface irregularities, forming an effective seal.

After shrinking, the imprint is permanent and solvent resistant.

Insulation Boot for Circuit Breaker is electrrical insulation boots ,designed to insulate Draw-Out Circuit Breakers in MV/HV Power Plant & Substations .This pliable tubes can be installed ,removed or replaced in few minutes. The bots are manufactured from high quality Non-tracking Cross-linked Polyolefin material to provide excellent electrical insulation and to withstand higher operating temperature continuously.Meets ANSI C37.20.2 standards.